Some operators have blamed the quality of the vehicle after an accident occurred in driving the electric forklift. In fact, they will be discovered after careful observation. Most of the accidents that occurred in Electric forklifts were caused by improper operation of drivers. Because the size of the electric forklift will be relatively small, some drivers will not pay much attention to some details during the operation, which will lead to accidents. What problems should be paid attention to when driving electric forklifts?

When driving an electric forklift to load any cargo, it is necessary to control the load center of the cargo. The distance from the center of the load is the center point of the electric forklift when the goods are forked. In simple terms, it refers to the center of the length of the cargo. point. For example, if the electric forklift needs to be loaded with a length of one meter eight meters, then the load center of the cargo is at a position of nine hundred millimeters. If the length of the cargo is three meters, then the center point of the load is at one-fifth. If the fork that barely uses the one-meter-two can be used, it will be prone to a rollover accident. It is also a kind of comparison. Adventurous approach.

When the electric forklift carries goods on the drive course, raising the fork too high will increase the overall height of the forklift, directly affecting the stability of the electric forklift in the driving process. Therefore, when carrying cargo transportation, the height of the fork cannot be lifted too high, and the low end of the fork should be kept between 3 and 40 cm in height from the ground, and it should not hinder the minimum during driving. The position and the gantry need to be tilted back, except that the load cannot be increased when loading or stacking. When entering or exiting the operation site or during transportation, it must be noted that there are no obstacles in the open space. If you are carrying a relatively large volume of cargo, you will be blocked by the driver`s sight. This should be Turn the electric forklift upside down.

When electric forklifts need to turn and retreat while driving, if there are Other vehicles and pedestrians around, warnings must be given in a timely manner. And you can't make a sharp turn at high speed, or else it will cause a rollover accident when the forklift loses its balance. Do not turn off when you encounter a downhill section. When the cargo loaded by the electric forklift is traveling uphill at a speed higher than the first speed or exceeding seven degrees, it is not possible to use the brake in special circumstances.